OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23EE

Camshaft B Position Signal Output Circuit High (Bank 1)

P23EE flags a camshaft B, bank 1 output line that the ECM cannot pull low: the voltage stays near supply level, pointing to a short to a battery-fed or 5 V wire, a faulty pull-up in the receiving unit or a failed ECM driver transistor. GM documents the test only for the bank 1 camshaft A counterpart P2616 on the 2019 LTG: monitored while the output is commanded low, a short once resistance to power drops to 0.5 ohm or below, a sample every 100 ms, 40 bad results in 50, Type C. No public manufacturer data exist for P23EE. A driver stage exposed to a hard short can overheat, so locating the short before replacing a module matters. Siblings: open circuit P23EC, low P23ED, the bank 2 high fault P23F1.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / EE

Possible causes

  • Output line shorted to a battery or sensor supply wire high
  • Faulty pull-up circuit in the receiving module medium
  • ECM driver transistor burnt out low

Symptoms

  • Code logged while the engine runs normally
  • Faults or reduced functions in the module fed by the signal

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23EE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication