OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23ED

Camshaft B Position Signal Output Circuit Low (Bank 1)

With P23ED the ECM detects that its camshaft B output for bank 1 reads low although it has released the line to go high. Most often a harness section rubbing through to the engine block, a crushed connector pin or a shorted input in the receiving module is to blame. Measured analogies come from GM: the bank 1 camshaft A output code P2615 uses a ground resistance of at most 0.5 ohm, requires the engine to be out of crank and is rated Type C, so no warning lamp. Whether makers who use P23ED light the MIL is not published. Because the sensor feeding the ECM is not involved, replacing the camshaft sensor will not clear the code; a voltage-drop test of the output line between both modules is the sensible first step.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / ED

Possible causes

  • Harness rubbed through against the engine block high
  • Crushed or bent connector pin touching ground medium
  • Shorted input in the receiving module medium
  • ECM output stage damaged low

Symptoms

  • Code stored, engine performance unaffected
  • Downstream module reports missing camshaft signal
  • Possible fallback behaviour in transmission or hybrid functions

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23ED

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication