OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23EC

Camshaft B Position Signal Output Circuit/Open (Bank 1)

P23EC belongs to the camshaft B group – on most layouts the exhaust camshaft – and refers to bank 1, the side with cylinder 1. The ECM rebroadcasts the phase signal of that camshaft on a dedicated output wire, and P23EC reports that this wire, or the driver stage feeding it, shows an open or undefined circuit condition. No manufacturer publishes P23EC; the closest documented logic is GM's for P2614 to P2616 on the camshaft A output, where an open of 200 kOhm or more is detected during the low-side test. CARB requires output circuits to be checked whenever another diagnostic relies on them. Low or ground faults are P23ED, high or battery faults P23EE. Drivability normally stays intact.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / EC

Possible causes

  • Open circuit in the camshaft B output wire high
  • Connector at the ECM or receiver not fully latched medium
  • Input stage of the receiving module defective low

Symptoms

  • Stored code, often found during a routine scan
  • Receiving module runs on substitute values

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23EC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication