OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23EB

Camshaft A Position Signal Output Circuit High (Bank 2)

P23EB is the opposite fault to P23EA: the bank 2 camshaft A output line, which the ECM drives as a switched low-side signal for another module, stays high when it should be pulled low. Typical reasons are a wire touching a supply circuit, moisture in a connector or a defective driver in the ECM. GM checks the bank 1 version P2616 while the output is commanded low and declares a short to power at 0.5 ohm or less, with system voltage at least 11 V and 40 of 50 samples failing (Type C, no MIL). Nothing comparable is published for P23EB itself, so these figures only serve as a guide. Unlike sensor codes such as P0345, the engine's own timing is not affected; the risk lies with the module downstream, which loses its phase reference.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / EB

Possible causes

  • Output wire shorted to a battery or 5 V supply wire in the harness high
  • Water ingress bridging terminals medium
  • ECM output transistor no longer switching to ground low

Symptoms

  • Code present without drivability complaint
  • Related fault codes in the receiving control module
  • Comfort functions such as start-stop deactivated

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23EB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication