OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23EA

Camshaft A Position Signal Output Circuit Low (Bank 2)

P23EA sets when the ECM's output line that relays the bank 2 camshaft A position signal to another control unit is pulled toward ground. The check is blocked during cranking: the module commands the output high and expects the line to rise; if it stays low, the wire is chafed against ground or the receiver has an internal short. GM's 2019 tables for the bank 1 equivalent P2615 give 0.5 ohm or less to ground, or 200 kOhm and more for an open, sampled every 100 ms, with 40 of 50 samples having to fail, rated Type C without MIL. No manufacturer lists P23EA publicly, so the GM values are an analogy. Depending on the receiver, shift quality or start-stop may suffer while the camshaft sensor itself is fine.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / EA

Possible causes

  • Output wire chafed through to ground on the engine or body high
  • Receiving module with an input shorted to ground medium
  • Moisture or dirt bridging terminals in a connector low
  • Output stage in the engine control module failed low

Symptoms

  • Code stored, engine running normally
  • Harsher shifts or delayed engagement if the transmission module uses the signal
  • Start-stop function switched off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23EA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication