OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23E9

Camshaft A Position Signal Output Circuit/Open (Bank 2)

P23E9 concerns a signal the engine control module sends out rather than one it receives: on some engines the ECM passes a conditioned copy of the bank 2 camshaft A position signal on to another module that needs engine phase information. The code flags a broken or otherwise faulty output line, typically an open circuit found when the driver stage is switched. No manufacturer documents P23E9 publicly. GM's tables for the bank 1 counterpart on the 2019 2.0 L LTG show the method: the driver voltage is compared with controller limits, and an open line above about 200 kOhm is caught during the low-circuit check, which is why P2614 may set alongside it. Ground faults belong to P23EA, shorts to voltage to P23EB. The engine itself usually keeps running normally.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / E9

Possible causes

  • Broken wire in the output line to the receiving module high
  • Terminal pushed back or corroded in a connector medium
  • Receiving module unplugged or without its load resistor medium
  • Faulty output driver inside the engine control module low

Symptoms

  • Stored code with no noticeable change in engine running
  • Fault entries in the module that receives the camshaft signal
  • Start-stop or shift functions may be restricted

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23E9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication