OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23E8

EGR C Flow Excessive Detected

P23E8 reports that more exhaust gas passes through the third recirculation path, C, than the module allows for the current operating point – the reverse of P23E7. A valve C that does not seat fully, a leaking bypass or a flow sensor reading too high are the usual explanations. CARB requires the OBD system to recognise EGR flow so high that the system can no longer bring it down to the commanded rate. No manufacturer documents P23E8 publicly. GM's 2011 6.6 L LGH diesel shows the equivalent logic for path A (P0402): actual and desired air mass are compared, and a controller deviation between 0.4 and 1.2 g per revolution between 1150 and 1600 rpm, held for 8 s, sets a Type B fault. Expect rough idle, stalling, misfire or smoke.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / E8

Possible causes

  • EGR valve C held partly open by carbon deposits high
  • Worn valve seat or leaking bypass in path C medium
  • Air-mass or EGR flow sensor reading off, so flow is overestimated medium
  • Control software needing an update low

Symptoms

  • Rough or unstable idle
  • Engine stalls when coming to a stop
  • Hesitation or misfire under load
  • Visible smoke on diesel engines

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23E8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication