P23E4
EGR C Control Circuit High
P23E4 is the high counterpart: the control circuit of EGR valve C carries a level that is too high. Typical are a drive line touching a battery feed, a connector pin bent onto a supply terminal, or an output stage that no longer pulls its side low. Unlike a ground short, a short to voltage can leave the actuator partly energized, so depending on the design the valve may move unexpectedly or not at all. The equivalents for valves A and B are P0490 and P045D. Which component carries the letter C differs between manufacturers, and none publishes P23E4 with thresholds. Under the CARB rule such output faults have to be detected. The engine usually runs normally, EGR path C is switched off and the warning lamp comes on. Related: P23E1, P23E3.
Possible causes
- Drive wire of valve C touching a battery feed high
- Bent pin in the valve C connector medium
- Engine module output stage not pulling low low
Symptoms
- Warning lamp on
- Valve C moves unexpectedly or not at all
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P23E4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.