P23E0
Cylinder 4 Fuel Heater Performance
P23E0 judges the effect of the cylinder 4 heater rather than its wiring: the circuit is intact, but the heat delivered or the temperature reached falls short of what the conditions call for. One factor specific to resistive heaters is supply voltage. Bosch specifies 260 W per heating element at 12 V; since power falls with the square of voltage, a weak battery at 10 V during cranking leaves only about 180 W, and warm-up takes noticeably longer. A performance code on one cylinder alone, however, points to that heater: an aged element, deposits or a poor contact. The engine control sets the heating demand from ethanol content and outside temperature, so the fault shows mainly in cold weather on high-ethanol fuel. No manufacturer documents P23E0; CARB expects functional monitoring.
Possible causes
- Aged heater at cylinder 4 with reduced output high
- Poor contact in the cylinder 4 heater circuit medium
- Weak battery or low system voltage during heating low
Symptoms
- Rough start in cold weather on high-ethanol fuel
- Longer cranking
- Engine warning lamp, depending on manufacturer
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P23E0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.