P23DC
Cylinder 3 Fuel Heater Performance
P23DC is set when the heating at cylinder 3 works electrically but delivers too little effect. Bosch writes that its heater unit follows the heat output of all four circuits and hands a temperature reading to the engine controller, so a channel that warms more weakly than the others can be singled out. Such systems exist because ethanol-rich fuel is hard to ignite in the cold: Brazilian flex cars long carried a small petrol tank for cold starts, and the 2009 VW Polo E-Flex was the first model to do without it. If cylinder 3 stays underheated, it misfires or runs lean during warm-up. Weak elements, deposits or a high-resistance joint are typical. No manufacturer documents P23DC or its limits; CARB asks for functional monitoring.
Possible causes
- Cylinder 3 heating element below its rated output high
- High-resistance crimp or plug in the cylinder 3 heater circuit medium
- Deposits insulating the heated surface low
Symptoms
- Misfire on cylinder 3 during warm-up on ethanol
- Lean running in the first minutes
- Engine warning lamp, depending on manufacturer
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P23DC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.