OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23DB

Cylinder 3 Fuel Heater Control Circuit Low

With P23DB the cylinder 3 heater control circuit is too low, meaning the line or the heater itself has found a path to ground. Because a single heat circuit is sized for several hundred watts, such a short trips the current limit at once; Bosch describes short detection per circuit and an integrated current relay in its Flexstart unit, which then cuts only the affected channel. Cylinder 3 starts on cold fuel while the remaining heaters keep working, so the engine shows roughness on one cylinder rather than a general cold-start problem. Water entering the connector, a damaged harness clip near the rail or an internally shorted heated injector are plausible causes. No manufacturer documents P23DB publicly; CARB requires circuit monitoring. Related: P23DA, P23D9, P23DC.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / DB

Possible causes

  • Water in the cylinder 3 heater connector high
  • Harness chafed through at a damaged clip near the rail medium
  • Heated injector at cylinder 3 shorted internally low

Symptoms

  • One-cylinder roughness when starting cold
  • Other cylinders start normally
  • Engine warning lamp, depending on manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23DB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication