OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23DA

Cylinder 3 Fuel Heater Control Circuit High

P23DA tells that the control side of the cylinder 3 heater sits at a high level. The likely pictures are a control wire touching a positive feed, so voltage stays on the line when the channel is off, or an output stage that has failed conducting, so heater 3 runs without command. The second case is the costly one: Bosch rates one heat circuit at about 260 W at 12 V, which is more than 20 A, and a heater that keeps running after the engine is shut off will drain the battery within a few hours. A heater 3 that is still warm long after switch-off, or an unexplained flat battery, fits this code. No manufacturer publishes P23DA; CARB requires the circuit to be monitored. Low fault: P23DB, open: P23D9, cylinder 2 counterpart: P23D6.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / DA

Possible causes

  • Channel 3 output stage failed conducting high
  • Cylinder 3 control wire shorted to a positive feed medium
  • Heater supply relay contacts welded low

Symptoms

  • Flat battery after the car has stood for some hours
  • Heater at cylinder 3 warm long after switch-off
  • Engine warning lamp, depending on manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23DA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication