OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23D8

Cylinder 2 Fuel Heater Performance

P23D8 concerns how well the cylinder 2 heater works, not its wiring. According to Bosch, the Flexstart heated rail warms pure ethanol fuel at rates of as much as 30 °C a second, so a system of this kind knows roughly how quickly each heating point ought to warm up. If cylinder 2 rises clearly slower than expected, draws less current than its neighbours or never reaches its target temperature, the performance code follows. Typical reasons are an aged element, scale or varnish on the heated surface and a corroded contact that drops voltage under load. No manufacturer documents P23D8 or its thresholds publicly; CARB expects functional checks of heated fuel preparation. The driver mostly notices a rough first minute on cold ethanol. Electrical faults on this path are P23D5 to P23D7.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / D8

Possible causes

  • Cylinder 2 heater element with reduced output high
  • Varnish or scale on the heated surface at cylinder 2 medium
  • Corroded contact dropping voltage under heater load medium

Symptoms

  • Cylinder 2 runs rough for about a minute after a cold ethanol start
  • Longer cranking below freezing
  • Engine warning lamp, depending on manufacturer

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P23D8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication