OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23D6

Cylinder 2 Fuel Heater Control Circuit High

P23D6 flags the control circuit of the cylinder 2 fuel heater as high. A heater driver typically checks the line both with the channel off and with it on; a level that stays near supply voltage in both states points to a control wire touching a positive feed or to a driver that no longer pulls the circuit down. Depending on the wiring, the heater then either stays energized or cannot be switched at all. Bosch documents that its Flexstart unit also diagnoses the FET switches of every heat circuit individually, and that is where a fault of this kind surfaces. P23D6 itself appears in no public manufacturer document, while CARB counts heated fuel preparation among the outputs to watch. Expect either a cold cylinder 2 at start or a heater that runs on. Low and open faults: P23D7, P23D5.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / D6

Possible causes

  • Cylinder 2 heater control wire touching a positive feed high
  • Switching FET of channel 2 failed in the conducting state medium
  • Bent connector pin touching a supply terminal low

Symptoms

  • Heater at cylinder 2 runs on or does not switch
  • Cylinder 2 starts cold on ethanol
  • Engine warning lamp, depending on manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23D6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication