OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23D5

Cylinder 2 Fuel Heater Control Circuit/Open

Cylinder 2 has its own fuel heating path on flex-fuel engines that warm the fuel per cylinder, and P23D5 says this path carries no current although the heater is commanded on, or the control line shows a general fault. To the heater unit the open simply looks like a missing load on channel 2. Bosch describes its Flexstart unit as checking each of four heat circuits for interruption and shorts and passing the result to the engine controller. No carmaker publishes P23D5 or its limits. CARB lists heated fuel preparation among the output systems to be monitored. Cylinder 2 then receives cold ethanol during the first seconds of a cold start. A quick check is to compare the resistance of heater 2 with that of its neighbours. Shorts on the same path are P23D6 and P23D7.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / D5

Possible causes

  • Heater at cylinder 2 burnt through (open element) high
  • Cylinder 2 heater plug loose or not latched after intake work medium
  • Broken conductor in the cylinder 2 heater lead medium
  • Channel 2 output of the heater control unit failed low

Symptoms

  • Cylinder 2 misfires briefly after a cold start on ethanol
  • Uneven idle in the first minute when cold
  • Engine warning lamp, depending on manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23D5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication