OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23D2

Cylinder 1 Fuel Heater Control Circuit High

P23D2 is the high-voltage fault on the cylinder 1 heater circuit; note that in this series the high code comes before the low code (P23D3). The control side of the heater shows supply voltage while it should be switched off, so the switching stage has lost control: a short to a positive wire or a switching element that no longer turns off are the usual reasons. A heater left energized keeps warming fuel at cylinder 1 after start and draws current constantly. No manufacturer documents P23D2 publicly. Bosch credits its Flexstart heater unit with diagnosing the switching FETs of each of its four heat circuits, which is the kind of check behind this code. CARB requires circuit monitoring of heated fuel preparation. Opens are P23D1.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / D2

Possible causes

  • Cylinder 1 heater control wire shorted to a positive feed high
  • Channel 1 switching element stuck on in the heater unit medium
  • Damaged connector letting the heater pin touch a supply pin low

Symptoms

  • Cylinder 1 heater stays on, higher current draw
  • Possible hot-restart problems
  • Engine warning lamp, depending on manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23D2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication