OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23D1

Cylinder 1 Fuel Heater Control Circuit/Open

Instead of one heater for the whole rail, some flex-fuel systems give every cylinder its own heating path, either a heated injector or an element at each rail outlet. P23D1 is the open or general circuit fault on the path for cylinder 1, so that cylinder gets unheated ethanol during a cold start. Bosch's Flexstart heating control unit supervises four separate heat circuits of about 260 W each and recognises interruptions, which matches this per-cylinder layout. No manufacturer documents P23D1 publicly. CARB lists heated fuel preparation as an output component to be monitored. Typically cylinder 1 misfires or contributes nothing in the first seconds after a cold start. Cylinders 2 to 4 follow from P23D5 onwards; a rail-wide heater uses P23CA.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / D1

Possible causes

  • Burnt-out heater at cylinder 1 (heated injector or rail element) high
  • Broken wire or unplugged heater connector at cylinder 1 medium
  • Corroded terminals in the cylinder 1 heater connector medium
  • Failed channel 1 output in the fuel heater control module low

Symptoms

  • Cylinder 1 misfire right after a cold start on ethanol
  • Rough idle until the engine warms up
  • Engine warning lamp, depending on manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23D1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication