P23D0
Fuel Heater Control Module Feedback Signal Circuit High
P23D0 applies when the return signal from the fuel heater control unit is stuck above its plausible maximum. A short to a voltage source on the feedback wire is the usual explanation; with a pull-up input in the engine module an open ground at the heater unit can produce the same picture. Because a pinned-high signal could be misread as an overheated heater, the engine module discards it and records a circuit fault instead. No manufacturer documents P23D0 publicly. Bosch's Flexstart unit is described as sending heat and diagnostic data back to the engine module, which is the signal checked here. CARB requires out-of-range detection on such monitored inputs. Fuel heating is usually switched off as a precaution. The low case is P23CF, implausible values P23CE.
Possible causes
- Feedback wire shorted to a voltage supply high
- Missing ground at the fuel heater control module medium
- Feedback output of the heater unit stuck high medium
- Faulty input stage in the engine control module low
Symptoms
- Fuel heating switched off as a precaution
- Poor cold starts on high ethanol blends
- Engine warning lamp, depending on manufacturer
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P23D0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.