P23CE
Fuel Heater Control Module Feedback Signal Performance
Unlike the open and short codes, P23CE concerns a feedback signal that is electrically present but does not fit what the engine module expects. The heater unit may, for example, report no temperature rise during a commanded heating phase, a rise that is far too slow, or values that contradict the command state. Bosch's Flexstart heater unit measures the heat it delivers and passes it on, so a weak heating element, poor contact on a high-current path or a drifting measurement can all surface here. No manufacturer documents P23CE or its thresholds publicly. CARB asks for functional checks on heated fuel preparation, not only circuit checks. Cold starts on ethanol may be slow even though no wire is broken; a missing signal is P23CD.
Possible causes
- Aged heating element delivering less heat than commanded medium
- High resistance at heater power or ground terminals medium
- Drifting temperature or current measurement inside the heater unit medium
- Weak battery reducing heating power during cranking low
Symptoms
- Slow or rough cold starts on ethanol without a wiring fault
- Engine warning lamp, depending on manufacturer
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P23CE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.