P23CD
Fuel Heater Control Module Feedback Signal/Open
Besides being commanded, a fuel heater control unit reports back to the engine module, so the engine knows whether heating actually took place. P23CD indicates that this feedback line carries no usable signal or is open. Bosch describes exactly such a return path for its Flexstart unit: the delivered temperature and diagnostic status are measured and handed on to the engine module, which uses them to dose the heating energy. No manufacturer documents P23CD publicly. Without feedback the engine module cannot confirm heater operation, may stop using fuel heating and cannot evaluate the individual heater circuits. CARB requires monitoring of heated fuel preparation. Implausible feedback is P23CE; shorts of the line are P23CF and P23D0.
Possible causes
- Broken feedback wire between heater unit and engine module high
- Loose or corroded pin for the feedback signal medium
- Heater unit without supply or ground, so it sends nothing medium
- Failed feedback output in the fuel heater control module low
Symptoms
- Cold-start fuel heating disabled or unconfirmed
- Harder starts on ethanol in cold weather
- Engine warning lamp, depending on manufacturer
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P23CD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.