P23C9
Fuel Heater Control Module Power Control Circuit High
P23C9 is stored when the power control line to the fuel heater control unit shows battery voltage although the engine module has it switched off, pointing to a short to a live wire. The real risk here is the reverse of the low case: the heater stage may be enabled without being asked, warming the fuel after it is no longer needed and loading the electrical system. No manufacturer documents P23C9 publicly. Bosch lists reverse voltage and internal overtemperature protection for its Flexstart heating unit, which limits damage, and the engine module normally only heats depending on ethanol content and outside temperature. CARB requires output circuits of heated fuel systems to be checked. P23C7 covers the open and P23C8 the low fault.
Possible causes
- Power control wire shorted to a battery or ignition feed high
- Welded relay contact keeping the circuit energized medium
- Internal leakage in the fuel heater control module medium
- Engine module output that does not switch off low
Symptoms
- Fuel heating active when not needed, possible battery drain
- Heater unit or wiring gets unusually warm
- Engine warning lamp, depending on manufacturer
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P23C9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.