P23C2
NOx Sensor Delayed Response - High to Low (Bank 1 Sensor 3)
P23C2 targets the dead time of NOx sensor 3 on bank 1 when NOx drops: the reading only starts to fall too long after the exhaust has changed, even if it then moves at a normal pace. CARB separates these two failure types in its oxygen sensor definitions, calling the time before a sensor first reacts delayed response and a sluggish transition slow response. No manufacturer documents P23C2 publicly. GM's 2025 table builds such a delay timer into the front-sensor test P22F9 for the rising edge: it runs from the moment the NOx model reaches 30 ppm until the sensor does, and more than 2 s counts as a fault. A partly blocked protective tube or aged cells are the usual reason. Sensors 1 and 2 use P24F4 and P24F5, while P23C0 stands for a slow falling transition.
Possible causes
- Protective tube partly blocked, so new exhaust gas reaches the cell late high
- Aged sensing cells reacting late to a change medium
- Condensate in the sensor housing after many short trips low
Symptoms
- Check engine light on
- Sensor 3 value holds briefly before dropping in overrun
- Engine runs normally
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P23C2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.