OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23BF

NOx Sensor Performance - Slow Response Low to High (Bank 1 Sensor 3)

P23BF concerns how quickly NOx sensor 3 on bank 1 follows a rise in NOx. The control module waits for an increasing transient and times the climb of the sensor signal against what a model predicts. No manufacturer publishes P23BF. GM's 2025 table demonstrates the method on the front sensor under P22F9: timing runs from 30 ppm up to 220 ppm, and the sensor fails when it trails by over 2 s or by more than a tenth of the model's time. For a probe behind two SCR catalysts this is harder, since little NOx is left to reach it. A Continental smart sensor is specified with a 33-66 % response time of 1300 ms when fresh and 1650 ms when aged. CARB counts response rate among NOx sensor performance faults. P22F9 and P22FC are sensors 1 and 2; P23C0 is the falling edge.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / BF

Possible causes

  • Soot, oil ash or urea residue blocking the gas inlet of the sensor high
  • Measuring cells aged beyond their response specification medium
  • Element running too cold because the heater is weak low

Symptoms

  • Check engine light on
  • Sensor 3 signal trails the front sensor during acceleration
  • No change in how the engine runs

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P23BF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication