OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23BE

NOx Sensor Performance - Signal Biased/Stuck Low (Bank 1 Sensor 3)

P23BE is the low-side mirror of P23BD: NOx sensor 3 on bank 1 shows less NOx than is plausible, or it stays near zero while the engine is clearly producing some. Behind a working SCR system the true value is small anyway, which makes a low-stuck sensor the more dangerous error for monitoring, because it can hide a failing catalyst. No manufacturer documents P23BE publicly. Ford's 2023 diesel summary sets a negative-offset limit of about 20 ppm for the front sensor under P2201. Volvo's troubleshooting guide treats the low-stuck counterparts P225D and P225F as a probe measuring outside air, so an exhaust leak or air entry is the likelier cause than the sensor. CARB lists gain-low failure modes for NOx sensors. P225D and P225F are sensors 1 and 2.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / BE

Possible causes

  • Exhaust leak or air drawn in ahead of sensor 3, diluting the gas high
  • Measuring cell lost sensitivity and reads too low medium
  • Sensor not seated correctly so it samples too little exhaust low

Symptoms

  • Check engine light on
  • Sensor 3 reads near zero under load
  • Possibly an audible exhaust leak at the rear section

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P23BE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication