P23BB
NOx Sensor Heater Resistance (Bank 1 Sensor 3)
P23BB says the heater element of NOx sensor 3 on bank 1 has a resistance outside its permitted band. Because the resistance of the ceramic heater climbs with temperature, it doubles as the thermometer of the probe, so an aged or cracked element heats poorly and reports a false temperature as well. No manufacturer publishes P23BB. GM runs the same kind of check on the post-second-catalyst sensor in 25OBDG04B but stores P23B5: the raw resistance may differ from its target by no more than 0.06 in relative terms, tested once supply and dew point have been valid for 200 s, 125 of 250 samples, Type A. Under CARB, the heater must be watched against the limits its supplier guarantees. P224A and P224B are the same fault on sensors 1 and 2; the usual remedy is a new sensor.
Possible causes
- Heater element aged by long service at high exhaust temperature high
- Element cracked by water droplets hitting the hot ceramic medium
- Added resistance from a corroded heater contact low
Symptoms
- Check engine light on
- Sensor 3 slow to become ready after a cold start
- Implausible NOx readings from the rear sensor
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P23BB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.