OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23B9

NOx Sensor Heater Sense Circuit High (Bank 1 Sensor 3)

P23B9 is the counterpart of P23B8: the temperature feedback wire of NOx sensor 3 on bank 1 carries a voltage that only a short to battery or to another live wire can explain. The sensor then cannot report a trustworthy heater temperature, so it withholds its NOx output. GM applies this check to the post-second-catalyst sensor in 25OBDG04B (2025) under the same frame as the ground short: powertrain relay above 11 V, sensor supply above 9.90 V, dew point reached, and half of 160 samples (80) must fail before this Type B code is stored. A harness overheated near the exhaust, where insulation melts between neighbouring wires, is a classic trigger; the same 21-NA-149 bulletin for the 3.0L LM2 includes P23B9. P2211 and P22A9 cover sensors 1 and 2.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / B9

Possible causes

  • Sense wire shorted to the heater supply or another battery-fed wire high
  • Harness insulation melted by contact with hot exhaust parts medium
  • Internal fault in the sensor or its control unit medium

Symptoms

  • Check engine light after two trips
  • No NOx reading from sensor 3
  • Possibly a blown fuse in the sensor supply

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P23B9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication