OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23B8

NOx Sensor Heater Sense Circuit Low (Bank 1 Sensor 3)

Smart NOx sensors report heater temperature through a separate sense connection, which GM calls the HTemp pin. P23B8 means this line on sensor 3 of bank 1 is pulled to ground. GM's 2025 table 25OBDG04B looks for the ground short on the post-second-catalyst sensor once the powertrain relay is above 11 V, the relay feeding the sensor bus is switched on, the supply exceeds 9.90 V and the dew point is reached; 80 of 160 samples at 25 ms must fail, Type B with two trips. For Continental Gen 3.5 sensors GM adds that the sensor itself waits 1.5 s before passing on an electrical fault. Bulletin 21-NA-149 names P23B8 where the engine harness of 3.0L LM2 trucks has rubbed through. P23B9 is the short to power; P2210 and P22A8 cover sensors 1 and 2.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / B8

Possible causes

  • Sense wire chafed through and touching body, frame or exhaust ground high
  • Water or salt bridging the sense pin to ground in the connector medium
  • Internal short in the sensor or its control unit medium

Symptoms

  • Check engine light after two trips
  • Sensor 3 does not report valid NOx values
  • Often stored together with other wiring-related codes

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P23B8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication