OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23B6

NOx Sensor Supply Voltage Circuit (Bank 1 Sensor 3)

P23B6 concerns the power feed of the third NOx sensor on bank 1, the smart probe behind the second SCR catalyst. Its built-in control unit needs a stable supply, and when the voltage it reports leaves the allowed range the engine module stores this code. GM's 2025 diesel table 25OBDG04B fails it below 9.90 V while the engine runs, the powertrain relay delivers more than 11 V and the dew point has been passed; it needs 125 bad readings among 250 taken every 25 ms and is rated Type B (two-trip MIL). In bulletin 21-NA-149 GM counts P23B6 among the codes produced by a chafed engine harness with blown fuses on 2021-2022 trucks with the 3.0L LM2. P220A and P220B are the same check on sensors 1 and 2; without proper supply the sensor sends no NOx values.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / B6

Possible causes

  • Blown fuse in the NOx sensor supply after a short elsewhere in the harness high
  • Supply or ground wire chafed through on the engine or frame (GM 3.0L LM2) medium
  • Corroded or loose pins in the sensor 3 connector under the vehicle medium
  • Weak battery or charging fault pulling the sensor supply down low

Symptoms

  • Check engine light after two trips
  • Sensor 3 shows no NOx value in live data
  • Further NOx sensor or communication codes stored at the same time

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P23B6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication