P23B3
NOx Sensor Heater Control Circuit High (Bank 1 Sensor 3)
If, on NOx sensor 3 of bank 1, the heater control pin sits at supply voltage when the electronics expect it to switch, P23B3 is stored. GM's 2025 diesel table 25OBDG04B describes it, for the sensor behind the second catalyst, as a battery short at the heater drive pin, evaluated every 25 ms with sensor supply above 9.9 V and dew point reached, and failing at 80 of 160 samples; Type B with the MIL on the second trip. GM also lists P23B3 in bulletin 21-NA-149 for 3.0L LM2 Duramax light trucks of 2021–2022. CARB requires the OBD system to catch heater circuit states that contradict the command, naming a short to 12 V as the example. As electronics and heater form one unit, the complete sensor is usually replaced once the harness is ruled out. P23B2 is the ground short.
Possible causes
- Heater control wire shorted to a supply line high
- Heater driver inside the sensor 3 electronics failed medium
- Heat-damaged connector with pins touching low
Symptoms
- Check engine light after two trips
- Sensor 3 heater status shows an error in live data
- SCR warning
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P23B3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.