P23AF
NOx Sensor Circuit High (Bank 1 Sensor 3)
With P23AF the third NOx sensor on bank 1 delivers a value above its measuring range. GM's 2025 diesel table 25OBDG04B sets the code when the raw reading of the post-second-catalyst sensor exceeds 2,990 ppm in 120 of 240 samples, provided the air system control is active or DEF dosing is ready; the rating is Type B, so the MIL follows on the second trip. For the 3.0L LM2 diesel in 2021–2022 light trucks, GM bulletin 21-NA-149 adds a practical hint: with P23AF the harness at the exhaust pressure differential sensor connector is checked by tugging on the single wires, because conductors may break there while still measuring fine, and extra tape is added afterwards. CARB requires detection of out-of-range NOx signals. P23AE is the low counterpart, P2203 the front sensor.
Possible causes
- Wire broken inside the insulation near a connector in the exhaust sensor harness high
- Sensor 3 failed with a reading stuck high medium
- Short between sensor lines in the harness low
Symptoms
- Check engine light after two trips
- Sensor 3 shows implausibly high NOx even at idle
- SCR efficiency code may follow
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P23AF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.