P23AE
NOx Sensor Circuit Low (Bank 1 Sensor 3)
P23AE is set when the third NOx sensor on bank 1 reports a concentration below anything physically possible. GM's 25OBDG04B table for its 2025 diesels requires the raw NOx value of the sensor behind the second catalyst to fall under −90 ppm in 100 of 200 samples, taken every 25 ms once dew point is reached, supply exceeds 9.9 V and no CAN fault is present; it is rated Type B with the MIL after two trips. GM bulletin 21-NA-149 lists P23AE among the codes caused by chafed engine harnesses on 3.0L LM2 Duramax pickups and SUVs of 2021–2022 (Silverado and Sierra 1500, Tahoe, Suburban, Yukon, Escalade). CARB demands out-of-range checks on NOx sensors. P23AF is the high limit, P2202 and P22A0 are the low codes of sensors 1 and 2.
Possible causes
- Engine harness chafed, disturbing the sensor 3 supply or signal high
- Sensor 3 with a negative offset from ageing or damage medium
- Water in the sensor connector low
Symptoms
- Check engine light after two trips
- Negative or zero NOx value for sensor 3 in live data
- Other harness-related codes stored at the same time
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P23AE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.