P23AC
NOx Sensor Circuit (Bank 1 Sensor 3)
P23AC is the general electrical fault reported for NOx sensor 3 on bank 1. The sensor's own control unit watches the leads between its electronics and the ceramic probe and tells the engine computer over CAN whether a measuring circuit is open or shorted; the user manual of Drivven's NOx sensor module kit, published by NI, lists these status states for the NOx and O2 circuits. No manufacturer documents P23AC publicly. For its front sensor, Ford's 2023 diesel summary sets P2200 when the probe lines Vs, COM, Ip1 or Ip2 short to battery or ground. CARB requires NOx sensor monitoring to catch broken circuits and readings outside the possible range. More specific sensor 3 codes run from P23AD to P23B0; P2200 and P229E are sensors 1 and 2. Without a valid signal the final SCR check stops.
Possible causes
- Lead between probe and sensor control unit damaged by heat or chafing high
- Corroded or loose terminals at the sensor 3 connectors medium
- Probe or sensor electronics failed internally medium
Symptoms
- Check engine light on
- No NOx reading from sensor 3 in live data
- SCR system warning
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P23AC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.