OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23A7

Exhaust Heat Exchanger Exhaust Bypass Valve B Stuck Closed

P23A7 is the opposite of P23A6: the second bypass valve (B) on the exhaust heat exchanger does not open on command and stays closed. Depending on the layout, all exhaust is then forced through the heat exchanger even when the engine is fully warm, which adds heat to the coolant and some back pressure – most relevant under load and in hot weather. The module recognises the condition from position feedback or from temperatures that do not follow the command. No manufacturer publishes P23A7, and the valve A version is P00E4. Ford's valve A cases, water inside the heat exchanger (SSM 51921) and a replaceable actuator kit (SSM 53003), are the nearest public examples. CARB requires output components to be checked for proper function. Keep an eye on coolant temperature until it is repaired.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / A7

Possible causes

  • Flap stuck closed by deposits or corrosion high
  • Actuator motor or gearing failed medium
  • Damaged or water-filled heat exchanger obstructing the flap low

Symptoms

  • Check engine light on
  • Coolant temperature higher than usual under load
  • Possibly reduced power or a changed exhaust note

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P23A7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication