P23A3
Exhaust Heat Exchanger Exhaust Bypass Valve B Control Circuit Low
With P23A3 the module sees the control line of exhaust bypass valve B sitting lower than its commanded state allows, which usually means that the wire or the driver stage of the actuator has found a path to ground. Water or road salt in a connector under the vehicle is a typical trigger. P23A3 itself appears in no public manufacturer document. For the valve A equivalent P237D, Ford's SSM 53003 on 2021–2023 F-150 PowerBoost hybrids blames the actuator mounted on the heat exchanger and supplies service kit PL3Z-5K245-B, while SSM 51921 links the code on Mavericks to water inside the heat exchanger. CARB expects such outputs to be monitored for out-of-range circuit states. If the flap cannot be driven, warm-up may take longer; P23A4 is the opposite short.
Possible causes
- Control wire chafed through and touching body or exhaust ground high
- Moisture or salt bridging pins in the actuator connector medium
- Internal short in the valve B actuator medium
Symptoms
- Check engine light on
- Heater output builds up slowly after a cold start
- Fault may reappear after rain or washing
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P23A3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.