OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P239C

Diesel Intake Air Flow B Control System - High Air Flow Detected

P239C belongs to the air-mass control loop rather than to the throttle alone: with the B intake throttle taking part in that control, the module sees more fresh air than its target and cannot bring the reading down even at the limit of its authority. Too little recirculated exhaust gas is both the usual cause and the consequence, from an EGR valve stuck shut, a blocked EGR cooler, a flap that cannot close or an air-mass meter reading high. No manufacturer was found that uses P239C. Ford's 2023 diesels run this test for their single intake throttle under P02EC, comparing desired and measured air mass against a speed/torque map; the 6.7 L needs 10 s, the 3.0 L 5 s. NOx emissions rise; driveability normally stays unchanged.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 9C

Possible causes

  • EGR valve stuck closed or EGR cooler clogged high
  • B throttle unable to close far enough medium
  • Air-mass meter reading too high medium
  • Boost higher than intended low

Symptoms

  • MIL on
  • No noticeable driving change in most cases
  • Often stored together with EGR flow codes

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P239C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication