OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2398

Diesel Intake Air Flow B Position Sensor Circuit Low

P2398 is logged when the position signal of the B intake throttle falls below its lower limit. Likely reasons are a signal lead shorted to ground, a lost 5 V supply, or a broken signal wire that the module input pulls low; on SENT sensors the transmitted raw value can also leave its range. No manufacturer documents P2398 itself. For the A valve, GM's LML reacts to less than 0.40 V persisting 5 s, its SENT-equipped 2017 diesels to under 1 % of 5 V in 200 of 250 checks (two trips), while Ford's 2023 diesels flag readings under 0.08 V lasting 3 s. If several 5 V sensors fail at once, suspect a shorted shared reference circuit. The flap is normally switched off, leaving the EGR loop with less control.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 98

Possible causes

  • Signal wire shorted to ground high
  • Open 5 V reference or open signal wire medium
  • Shared 5 V reference pulled down by another faulty sensor medium
  • Internally failed position sensor low

Symptoms

  • MIL on
  • Further 5 V sensor codes at the same time
  • Regeneration suspended

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2398

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication