OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2396

Diesel Intake Air Flow B Position Sensor Circuit

P2396 is the general electrical fault of the sensor that reports the angle of the B intake throttle, a potentiometer or, on newer units, a contactless Hall sensor with analogue or SENT output. The code says only that the signal is electrically implausible, without telling whether the reading sits under or over its window; makers that separate the two would set P2398 or P2399 instead. No manufacturer was found that uses P2396. On the A side the LML 6.6 L Duramax tables from GM accept 0.40 to 4.72 V and Ford's 2023 diesels 0.08 to 4.92 V before they set their split codes. Without a valid position the module cannot run closed-loop control and usually de-energises the flap. Check the 5 V reference, ground and signal wire and the connector before replacing the throttle unit, which normally contains the sensor.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 96

Possible causes

  • Corroded or loose sensor connector high
  • Damaged reference, ground or signal wire medium
  • Failed position sensor in the throttle unit medium

Symptoms

  • MIL on
  • Flap switched off, EGR runs with limited control
  • Regeneration postponed

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2396

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication