P238D
Water in Fuel Sensor B Circuit High
P238D reports that the signal of water-in-fuel sensor B sits above its valid range, usually from an open circuit, a disconnected sensor or a short to voltage. Stellantis case file S2214000004 documents it for 2022 Ram 2500, 3500, 4500 and 5500 trucks: the water warning lamp or message comes on at low mileage, and the cause is water that a pressure washer or similar spray drove into the plug of the filter housing on the frame rail. Technicians inspect both connector halves; corrosion means replacing filter housing and harness connector, plain water means drying, dielectric grease and a retest, with a new housing if the code returns. Stellantis stresses that P238D is not P238F, which reports actual water. P238C is the low counterpart.
Possible causes
- Spray water in the connector at the chassis-mounted fuel filter high
- Corroded terminals on harness or filter housing side medium
- Sensor in the filter housing failed medium
- Open signal or ground wire low
Symptoms
- Water-in-fuel lamp or message on at low mileage
- No water found when draining
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P238D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.