P2386
EGR Sensor E Circuit High
P2386 says the signal of EGR sensor E sits at or above the upper end of its electrical range. With a typical three-wire 5 V pressure or position sensor that happens when the ground is open or the signal line touches a supply voltage; on a temperature sensor wired as a pull-up, an open circuit shows the same picture. No manufacturer documents P2386 publicly. The pattern GM publishes for sensor D on its 2025 diesels gives a sense of scale: P2381 sets once the raw value exceeds 99.83 % of range in 480 of 600 samples, as a Type A fault. CARB asks for out-of-range checks on EGR monitor inputs. P2387 is the low-side counterpart. Expect the MIL and reduced or disabled EGR; the engine itself normally runs on.
Possible causes
- Open sensor ground wire or ground terminal high
- Signal wire shorted to 5 V reference or battery voltage medium
- Sensor output stuck high internally medium
Symptoms
- MIL on
- EGR shut off or reduced
- Scan data shows sensor E at full scale
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2386
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.