P2383
EGR Sensor D Circuit Range/Performance
P2383 flags an EGR sensor D whose signal is electrically fine but makes no sense. Two published strategies show how differently makers test it. GM's 2025 diesel ECM tables check the low-pressure EGR differential pressure sensor at key-off, when there should be no pressure difference: if the averaged reading exceeds 6 %, a Type A fault is set at once, provided no circuit or intermittent fault is present. Ford's 2024–2025 petrol summary uses P2383 for reversed hoses on its EGRP pressure sensor, judged by a signal off by more than 10 kPa or an internal temperature off by more than 27.7 °C for 5 seconds. GM bulletin 21-NA-149 adds harness checks at the sensor connector on 3.0L LM2 trucks. Mixed-up or cracked hoses, a drifting sensor and soot in the lines are the usual suspects.
Possible causes
- Sensor hoses swapped, cracked or disconnected (Ford EGRP) high
- Sensor drifted so that it reads a pressure difference with the engine off (GM) medium
- Sensing lines blocked by soot or condensate medium
- Intermittent wire break at the sensor connector (GM 21-NA-149) low
Symptoms
- Check engine light on
- EGR rate reduced or switched off
- Often appears after work on the EGR or exhaust system
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2383
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.