P2382
EGR Sensor D Circuit Low
P2382 reports that EGR sensor D delivers almost no signal voltage. In GM's 2025 diesel ECM tables this sensor measures the pressure difference across the low-pressure EGR path, and the code sets once the raw value drops below 0.02 % of range in 480 of 600 samples, sampled every 6.25 ms once the engine is out of cranking and the relay supply exceeds 11 V; it is a Type A fault with MIL on the first trip. Behind a reading that low there is usually a broken 5 V reference, a signal line shorted to ground or a sensor without output. For the 3.0L LM2 diesel, GM bulletin 21-NA-149 advises, for P2382 and P2383, pulling gently on each wire at the differential pressure sensor connector, since conductors may break there although they test good, and taping the harness afterwards. P2381 is the high-side code.
Possible causes
- Conductor broken right at the sensor connector (GM 21-NA-149) high
- Open 5 V reference or signal shorted to ground medium
- Differential pressure sensor without output medium
Symptoms
- Check engine light on in the first trip
- Low-pressure EGR switched off
- Fault may come and go with engine vibration
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2382
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.