OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P237E

Exhaust Heat Exchanger Exhaust Bypass Valve A Control Circuit High

P237E is logged when the driver for exhaust bypass flap A on a heat recovery unit sees a control voltage above its expected range. The likely story is a short from the control wire to a supply feed or an actuator whose internal driver has failed in a way that pulls the line up. The flap then no longer follows the warm-up strategy. Ford is the one maker that names the code publicly, and only once: SSM 53003 lists P237E together with P237C, P237D, P237F, P2C22 and P2C23 for 2021–2023 F-150 hybrids with the 3.5L PowerBoost and blames the actuator mounted on the heat exchanger, which is replaced with a service kit after normal diagnosis. A lit MIL is reported. P237D is the low-side mirror image and P23A4 the same fault on valve B; a high signal rarely heals by itself.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 7E

Possible causes

  • Heat exchanger bypass actuator with failed internal driver (Ford F-150 SSM 53003) high
  • Control wire shorted to a supply circuit in the harness medium
  • Heat-damaged connector with bridged pins low

Symptoms

  • Check engine light on
  • Cabin heat may build up later on cold days

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P237E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication