OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P237C

Exhaust Heat Exchanger Exhaust Bypass Valve A Control Circuit/Open

Some hybrids route the exhaust through a coolant heat exchanger after a cold start to warm the engine and cabin sooner, and flap A sends the gas around it once heat is no longer wanted. P237C is set when the drive circuit of that bypass actuator shows an open or a general circuit fault. Ford uses it on its full hybrids: on the Maverick 2.5L of 2022 and 2023, SSM 51921 traces P237C with P237D and P2C22 to water inside the heat exchanger, which is replaced; on 2021–2023 F-150 3.5L PowerBoost trucks built up to 1 March 2023, SSM 52050 blames the bypass control valve and replaces the muffler inlet pipe, while SSM 53003 offers an actuator kit. The bulletins report the MIL lit. P237D and P237E narrow the fault to low or high; P23A2 is valve B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 7C

Possible causes

  • Water inside the heat exchanger assembly or actuator (Ford Maverick SSM 51921) high
  • Bypass valve actuator with open winding or failed electronics high
  • Broken wire or loose connector in the hot area under the vehicle medium

Symptoms

  • Check engine light on
  • Engine and cabin may warm up more slowly in cold weather
  • Further heat exchanger codes such as P2C22 stored alongside

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P237C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication