P237A
O2 Sensor Exhaust Sample Error (Bank 1 Sensor 2)
P237A says the rear oxygen sensor of bank 1 is not getting, or not reporting, a representative sample of exhaust: its reading does not fit the gas that should be flowing past it after the catalyst, typically because outside air enters through a leak or the sensing element is no longer exposed properly. No manufacturer documents P237A publicly. Volkswagen describes the front-sensor counterpart P2414 for the 2014 Golf with signal windows of 3.10 to 4.81 V and 2.5 to 3.2 V, which gives an idea of how such a plausibility check is built. CARB requires rear sensors to be monitored for faults that would spoil their use in catalyst and fuel control monitoring. P2414/P2415 cover sensor 1; code lists repeat this title under P23A0. Drivability is normally unaffected, but catalyst diagnosis becomes unreliable.
Possible causes
- Leak at a flange, joint or cracked pipe ahead of the bank 1 rear sensor drawing in air high
- Rear sensor element damaged, coated or loose in its boss medium
- Contaminated or blocked reference air path of the sensor (wiring or connector) low
Symptoms
- Check engine light on
- Catalyst monitor not completing or reporting implausible results
- Possible ticking exhaust noise from a leak
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P237A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.