P2377
Turbocharger/Supercharger Inlet Pressure Sensor B Circuit High
P2377 means sensor B ahead of the compressor delivers a voltage above its upper limit. Publicly no manufacturer defines this B code, so GM's P012D for the supercharged LT4 serves as a reference: it trips above 97 % of the 5 V reference, which equals about 124 kPa at that sensor, again with 320 failed samples out of 400 at 12.5 ms intervals and Type B. Upstream of a compressor the pressure cannot rise far above ambient, so such a reading is not physical. Typical faults are a signal wire touching the 5 V supply or battery voltage and an interrupted sensor ground, after which the output rises to the reference. Moisture that has crept into the connector can also create a path to the supply. P2376 is the opposite low-voltage case.
Possible causes
- Signal wire shorted to 5 V reference or battery voltage high
- Sensor ground of sensor B open medium
- Moisture bridging terminals in the connector low
Symptoms
- Check engine light on
- Implausibly high inlet pressure in live data
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2377
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.