P2376
Turbocharger/Supercharger Inlet Pressure Sensor B Circuit Low
P2376 is set when the output voltage of compressor inlet pressure sensor B drops below its lower limit. No maker documents the B code publicly; GM's A version P012C on the supercharged LT4 gives an idea of the scale. There the threshold is 3 % of the 5 V reference, equal to roughly 6 kPa – a value no intake can reach in reality. The check runs continuously with one sample every 12.5 ms and fails once 320 of 400 samples are below the limit, so a steady fault is caught within a five-second window; the code is Type B. Typical reasons are a signal lead touching ground, a broken 5 V feed or a dead sensor. The ECM falls back on a substitute value and may cap boost on that compressor.
Possible causes
- Signal wire of sensor B shorted to ground high
- 5 V reference to sensor B open medium
- Sensor B failed medium
Symptoms
- Check engine light on
- Live data show an inlet pressure far below ambient
- Possible boost limitation
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2376
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.