P2372
Fuel Volume Regulator B Control Circuit Low
P2372 says the line driving fuel volume regulator B is pulled too low, as a rule by contact with ground. No manufacturer documents this B code publicly; it mirrors P0003 on regulator A. Ford's 2023 diesel detects that condition with the valve switched off: the voltage reported by the driver chip then falls below 2.8 V, where about 5 V would be normal. Deutz's EMR controller files a ground short on the feeding (high-side) wire of its volume control valve under P0003-00. Which side the short touches matters: on the feed side the valve loses its current, on the switched ground side it can be energised all the time, so delivery of pump B no longer follows the command. Chafed harness sections near hot engine parts are the classic finding.
Possible causes
- Control wire chafed through to ground high
- Moisture in the regulator connector medium
- Internal short in the regulator coil low
Symptoms
- Check engine light on
- Rail pressure too high or too low depending on the affected side
- Limp-home with reduced power
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2372
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.