P2368
Cylinder 12 Pressure Sensor Circuit Low
P2368 is stored when the voltage coming from the cylinder 12 pressure sensor stays below its lower limit. As the last cylinder of a V12 or W12, it has no publicly documented application, so Saab's 9-5 diesel code P0397 serves as the template. There, the scan tool shows peak combustion pressure in a normal band of 0 to 9,000 kPa; a signal wire touching ground or a missing 5 V reference pins the value at the bottom. In Saab's test an intact signal path jumps above 10,000 kPa once the plug is disconnected – a reading that stays low with the connector off therefore points to the harness rather than the sensor. Being a Type B code there, it needs two faulty trips before the lamp lights. The opposite case is P2369.
Possible causes
- Signal wire shorted to ground high
- 5 V reference open or shorted to ground medium
- Sensor electronics in the glow plug head failed low medium
Symptoms
- Warning lamp after two trips with the fault
- Peak pressure of cylinder 12 stuck near zero
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2368
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.