P2367
Cylinder 12 Pressure Sensor Circuit Range/Performance
With P2367 the cylinder 12 pressure signal is electrically within its limits but makes no sense for the operating point. A natural yardstick is the motored cycle: on overrun nothing burns, so the curve has to peak at top dead centre. Saab's 9-5 diesel uses exactly this peak position to locate true TDC and keeps in EEPROM how far the crank trigger wheel sits off its nominal angle – which shows how closely the ECM follows each sensor. A sensor whose peak shifts, whose zero has drifted or whose seat lets gas escape would fail such a check. No manufacturer documents P2367, because no twelve-cylinder engine with this sensor is public; the cylinder-1 equivalent is P0396. In most cases only the warning lamp is noticed.
Possible causes
- Sensor zero point or gain drifted high
- Combustion gas escaping at the glow plug seat medium
- Glow plug of a different calibration fitted low
Symptoms
- Check engine light on
- Implausible peak pressure value for cylinder 12 compared with the others
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2367
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0397-p0398-p03a1-p03a2-p03ab-p03ac-p03b5-or-p03b6
- law.cornell.edu/regulations/california/13-CCR-1968.2
- borgwarner.com/aftermarket/diesel-cold-start-ignition/pressure-sensor-glow-plugs