OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2362

Cylinder 11 Pressure Too High

P2362 is stored when cylinder 11 shows more combustion pressure than the ECM considers plausible. No manufacturer publishes it, because no twelve-cylinder engine with cylinder pressure monitoring is documented. On a diesel, excess pressure usually comes from the fuel side: an injector that leaks or hangs open adds fuel, injection timed too early raises the peak, and a sensor drifting upward fakes the effect. That this code family can also be triggered by software logic is shown by Audi's 2015 S3: a December 2018 bulletin, superseding one from 2015, cured the cylinder 1–4 versions with an ECM update. Sustained high peak pressure loads pistons and head gasket, so an ECM may shut the cylinder off. Harsh combustion noise and, after a shutdown, reduced power are the signs.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 62

Possible causes

  • Injector of cylinder 11 leaking or hanging open medium
  • Injection timing too early for this cylinder low
  • Engine control software misjudging the pressure medium
  • Pressure sensor drifting high low

Symptoms

  • Warning lamp on
  • Harsh combustion noise
  • Loss of power if the cylinder is shut off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2362

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication